Fully automatic cleaning mode: The PCBA runs parallel on a mesh belt with a width of W600mm. Meanwhile, the heated cleaning solution is sprayed at high pressure and in equal directions through the spray arms. The entire process of automatic cleaning, rinsing (opening the loop), and drying;

Full-process visualization: Tempered glass visualization window, making the cleaning process clear at a glance.

Scientific nozzle design (patent): It adopts a gradually increasing distribution on both sides - thorough cleaning, and the spray arm and nozzle are detachable.

Adjustable pressure of the visual nozzle: It solves the problem of collision and splashing of small-sized workpieces under high-pressure spray conditions during cleaning.

The viewing window and the entrance are equipped with photoelectric protection to prevent the cleaning solution from splashing out, and the plate drop detection ensures its safety.

Comprehensive cleaning system: The standard dilution tank and spray rinse tank are both equipped with heating systems, which enhance the cleaning efficiency. Shorten the cleaning time and be compatible Run water washing or chemical cleaning for SMT; Thoroughly and effectively clean the organic and inorganic contaminants such as rosin and solder paste remaining on the surface of THT's PCBA.

Equipmentparameters

Content	Parameters
Size of the cleaning area	The total length of the three cleaning sections is 1140MM
Equipment appearance dimensions:	5000MM* 1960MM*1840MM
Process flow:	Into the board section, water vapor separation, pre-cleaning - clean clean 1-2 - chemicals isolation - drainage chamber - rinse -- rinse -- rinse 1 2 - the final spray - wind cut 1 - the wind cut 2 - drying - the plate - drying 2 paragraphs
Capacity calculation	Mesh belt speed: Adjustable from 0.1 to 1.5 meters per minute. It is recommended to adjust the working speed to 0.4-0.5 meters per minute. Reference: For 450mmX100mm plates, the plate placement spacing is 5mm, and the working speed is 0.5 meters per minute
	Output: approximately 13 square meters per hour; Calculation method: Total width/Mesh belt speed Example: 150*200mm plate, output per hour: approximately 450PCS/H. This output is for reference only and subject to actual conditions. Calculation method: total square meters/single square meters
Conveying surface height	950±50mm(adjust)
Entrance and exit direction:	Left in, right out (viewed from the front window of the unit)
Exhaust volume (air extraction volume) :	about36M³/Min ；Exhaust outlet diameter: 250mm, three at the front, middle and rear
Weight:	about1800KG
Power supply requirements	AC380/3P/50H ；Total power: 102Kw/ 160A Rated operating power: 55Kw/85A

Inquiry Cart 0